LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1993 >> Crown Victoria Base >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Suspension - Rear Electronic Air >> Removal & Installation >> Air Spring >> Removal

Air Spring: Removal

  1. Turn air suspension switch, located in luggage compartment, to OFF position. See Figure . Raise vehicle on hoist so rear suspension is at full extension. Remove heat shield as required.
  2. Disconnect electrical connector at air spring solenoid. Bleed air from suspension system. See AIR SPRING SOLENOID. Remove air spring solenoid.
  3. Remove spring piston-to-axle spring seat by inserting Air Spring Remover (T90P-5310-A) between axle tube and spring seat on forward side of axle. Position remover so its flat end rests on piston knob. Push downward, forcing piston and retainer clip off axle spring seat. Remove air spring.
scientia non olet · About LEMON Manuals