LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1992 >> Festiva GL, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Rear Brake Caliper & Pads >> Removal (Capri)

Removal (Capri)

  1. Raise and support vehicle. Remove tire and wheel assembly. Using needle-nose pliers, remove parking brake return spring. Loosen parking brake cable housing adjusting nut. Remove cable housing from bracket on lower control arm. Loosen parking brake cable bracket-to-caliper attaching bolt. Remove parking brake cable from caliper.
  2. Remove lower caliper retaining bolt. Pivot caliper upward on upper caliper guide pin. Remove brake pad retaining spring, pads and shims. If replacing rear brake pads only, reverse removal procedure to install. If removing caliper, proceed to next step.
  3. Remove attaching clip from brake flex hose. Remove flex hose banjo bolt from caliper and discard copper washers. Remove lower caliper retaining bolt. Using a cold chisel, remove upper caliper guide pin dust cap. Using an Allen wrench, remove upper caliper guide pin. Lift caliper off rotor.
scientia non olet · About LEMON Manuals