LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1992 >> Explorer 4D Utility, RWD, Automatic >> Repair and Diagnosis (Single Page) >> Suspension >> Front Suspension >> Suspension - Front (4WD Coil) >> Steering Knuckle R & I >> Removal

Steering Knuckle R & I: Removal

  1. Remove spindle and shaft assembly. See SPINDLE & SHAFT ASSEMBLY R & I. Disconnect steering linkage from steering knuckle.
  2. Remove cotter pin and loosen ball joint nuts. Strike steering knuckle near ball joint to release ball joint. Remove ball joint nuts. Note position of camber adjuster on top of axle. See Figure. Remove camber adjuster and steering knuckle.
CAUTION: Camber adjuster must be installed in original location to maintain proper wheel alignment.
scientia non olet · About LEMON Manuals