LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1992 >> Explorer 4D Utility, RWD, Automatic >> Repair and Diagnosis (Single Page) >> Steering >> Steering Column >> Removal & Installation >> Steering Wheel & Air Bag >> Removal & Installation (Aerostar & Van)

Removal & Installation (Aerostar & Van)

  1. Set front wheels in straight-ahead position. Disconnect and shield battery negative and positive cables. Wait at least one minute to deplete charge in air bag back-up power supply. Remove air bag module-to-steering wheel retaining nuts. Remove air bag from steering wheel and disconnect air bag module electrical connector.
  2. Disconnect horn switch and speed control (if equipped) electrical connectors. Mark steering wheel-to-steering shaft position for installation reference. Remove steering wheel retaining bolt. Using Steering Wheel Remover (T67L-3600-A), remove steering wheel.
  3. To install, reverse removal procedure. Tighten steering wheel retaining bolt and air bag retaining nuts to specification. See TORQUE SPECIFICATIONS  .
scientia non olet · About LEMON Manuals