LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1992 >> Explorer 4D Utility, RWD, Automatic >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> A/C Compressor >> A/C Compressor Overhaul >> NIPPONDENSO 10PA20 10-CYL >> Shaft Seal >> Removal

Shaft Seal: Removal

  1. Discharge A/C system using approved refrigerant recovery/recycling equipment, and remove compressor. Drain oil from compressor, and measure amount drained.
  2. Remove clutch assembly. Remove front head retaining bolts. Separate front head and "O" ring from compressor. See Figure.
  3. Remove felt dust seal and dust seal retainer from front head. Remove shaft seal retaining snap ring. Press seal from front head.
scientia non olet · About LEMON Manuals