LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1992 >> Explorer 4D Utility, RWD, Automatic >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> A/C Compressor >> A/C Compressor Overhaul >> NIPPONDENSO 10P15A 10-Cylinder >> Shaft Seal >> Removal

Shaft Seal: Removal

  1. Discharge A/C system using approved refrigerant recovery/recycling equipment, and remove compressor. Drain oil from compressor, and measure drained amount. Remove clutch assembly.
  2. Remove manifold assembly from top of compressor. Clean compressor front hub area. Using Ring Remover (T71P-19703-C), remove retaining ring from front of compressor shaft.
  3. Remove felt seal from front of compressor. Remove front head retaining bolts and front head from compressor. Remove snap ring from rear of front head. Remove seal from rear of front head.
scientia non olet · About LEMON Manuals