LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1992 >> Explorer 4D Utility, RWD, Automatic >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> A/C Compressor >> A/C Compressor Overhaul >> NIPPONDENSO 10P13, 10P15, 10P15C & 10P15F 10-CYL >> Shaft Seal >> Removal

Shaft Seal: Removal

  1. Discharge A/C system using approved refrigerant recovery/recycling equipment, and remove compressor. Drain oil from compressor, and measure drained amount.
  2. Mount compressor in vise clamping on mounting ears. Remove clutch plate and clutch plate shims.
  3. Clean compressor front hub area. Remove felt packing and dust seal retainer from inside compressor nose. See Figure. Using Shaft Key Remover (T81P-19623-NH), remove key from shaft.
  4. Remove seal seat retaining snap ring. Clean inner bore of compressor nose. Using Shaft Seat Remover/Installer (T87P-19623-B), remove seal seat.
  5. Using Shaft Seal Remover/Installer (T87P-19623-AH), remove seal by pushing downward on shaft seal remover/installer and rotating clockwise to engage seal tangs. Pull seal from compressor.
scientia non olet · About LEMON Manuals