Removal (Bronco & F150/250 With Manual Locking Hubs)
- Raise and support front of vehicle. Remove front wheels. Remove locking hubs. See LOCKING HUBS article in the DRIVE AXLES Section. Remove caliper with brake line attached and secure to frame with wire. DO NOT hang caliper with any tension on brake hose.
- Remove hub bearing lock nut, lock ring and adjusting nut. Using Spanner Lock Nut Wrench (T86T-1197-A), remove nuts. Remove hub and rotor. Outer bearing will slide off with hub. Remove grease seal and inner bearing. If bearings require replacement, remove races from hub with Internal Puller (T77F-1102-A) and attached slide hammer.