LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1992 >> Explorer 4D Utility, RWD, Automatic >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Differentials & Drive Axles >> Drive Axle - Front (DANA Ifs) >> Removal & Installation >> Hubs & Bearings >> Installation & Adjustment (Bronco & F150/250 With Manual Locking Hubs)

Installation & Adjustment (Bronco & F150/250 With Manual Locking Hubs)

  1. If bearings are replaced, drive new races into hub. Lubricate bearings with lithium base multipurpose wheel bearing grease. Install inner bearing and seal into hub.
  2. Install hub and rotor assemble on spindle. Install outer bearing and adjusting nut. Using torque wrench and Spanner Lock Nut Wrench (T86T-1197-A) tighten adjusting nut to 50-60 ft. lbs. (68-81 N.m) while turning wheel back and forth.
  3. Applying inward pressure to spanner lock nut wrench to disengage locking splines, back off adjusting nut approximately 1/2 turn (180 degrees). Retighten adjusting nut to 15 ft. lbs. (20 N.m). Check hub and rotor assembly end play. End play should be 0-.004" (0-.10 mm). To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals