LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1992 >> Explorer 4D Utility, RWD, Automatic >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Differentials & Drive Axles >> Drive Axle - 7.5" & 8.75" TRAC-LOK Limited Slip >> Overhaul >> Disassembly

Drive Axle - 7.5" & 8.75" TRAC-LOK Limited Slip: Overhaul: Disassembly

WARNING: Preload spring is under pressure; remove carefully.
CAUTION: DO NOT  clean clutch plate friction surfaces with solvent; wipe with clean shop towel only. DO NOT  interchange clutches or shims.
  1. Remove ring gear. DO NOT  remove ABS sensor ring (if equipped). If sensor ring is removed, it must be replaced. Remove pinion shaft lock bolt and pinion shaft. Grasp preload spring with pliers. Pull and tap preload spring until it is removed.
  2. Using Pinion Gear Rotator (T84P-4205-A for 7 1/2" ring gear; T80P-4205-A for 8 3/4" ring gear) with a 12" extension, rotate pinion gears until they can be removed from differential case. Remove both side gear and clutch pack assemblies, marking each assembly for installation reference. Disassemble side gear and clutch pack assemblies; note order of disassembly for reassembly reference.
scientia non olet · About LEMON Manuals