LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1992 >> Explorer 4D Utility, RWD, Automatic >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Differentials & Drive Axles >> Differential - 8.75" & 10.25" >> Removal & Installation >> Axle Shaft & Bearing >> Removal (Full-Floating)

Removal (Full-Floating)

  1. Set parking brake and loosen 8 axle shaft bolts. Raise vehicle, keeping axle parallel to floor. Release parking brake.
  2. Remove wheel assembly and brake drum (back off rear brake adjustment if necessary). See Fig 1 . Discard push-on drum retainer nuts. Remove axle shaft bolts and remove axle shaft.
    NOTE: Left-side hub nut has left-hand threads. Right-side hub nut has right-hand threads. Hub nut is stamped with RH for right side, or LH for left side.
  3. Install Hub Wrench (T85T-4252-AH ) so drive tangs engage 4 slots in hub nut. Remove hub nut. Hub nut will ratchet during removal.
  4. Install Step Plate Adapter (D80L-630-7 ) onto spindle. Install Hub Puller (D80L-1002-L ) onto hub assembly. Loosen hub to point of removal. Remove puller and step plate. Remove hub assembly.
  5. Place hub in soft-jawed vise. Remove hub oil seal and inner bearing. Reposition hub in vise and remove inner and outer bearing race with brass drift.
    Fig 1: Exploded View Of Full Floating Axle Assembly
    G91H13372Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals