LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1992 >> Explorer 4D Utility, RWD, Automatic >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Differentials & Drive Axles >> Differential - 8.75" & 10.25" >> Removal & Installation >> Axle Housing Assembly >> Installation (Bronco, Pickup, Ranger & Van)

Installation (Bronco, Pickup, Ranger & Van)

  1. To install, reverse removal procedure. Apply thread sealant to brake junction block bolt prior to installation. Connect vent hose to axle housing. Apply Loctite to drive shaft flange bolt threads before installing. Ensure reference mark on drive shaft flanges are aligned.
  2. Before installing housing cover, ensure all sealing surfaces are clean. Apply a 3/16" diameter bead of silicone sealant on housing cover sealing surface on inside area of bolt holes. Install housing cover and retaining cover bolts. Tighten all bolts and nuts to specification. See TORQUE SPECIFICATIONS  table. Fill differential until fluid level is approximately 1/4" below bottom of filler plug hole.
scientia non olet · About LEMON Manuals