Disc Brake Calipers & Pads: Installation

Use "C" clamp to push caliper piston into piston bore until it bottoms out. To install, reverse removal procedure. Bleed air from brake system.

1. Install slide pin assemblies. Lubricate slides with Disc Brake Caliper Slide Grease D7AZ-19590-A (ESA-M1C172-A) or equivalent. Position shoes onto spindle.
2. Rotate caliper back up into position. Position caliper to spindle.
3. Install anchor bolt(s) through caliper and spindle. Tighten bolts to 85-100 ft.lbs. (115-135 N.m). Replace bolt washers (each side of inlet block). Reconnect fluid line. Tighten inlet block bolt to 10-15 ft.lbs. (13.6-20.3 N.m). Bleed system.
4. Install wheel and tire assemblies. Remove safety stands and lower vehicle. If brakes were not bled, check fluid level in master cylinder reservoir and fill if required. Pump brake several times to make sure you get a firm pedal. Operate vehicle to check brake operation.