LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1992 >> Explorer 4D Utility, RWD, Automatic >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Overhaul >> Master Cylinder >> Disassembly

Master Cylinder: Disassembly

  1. Remove master cylinder. Clean outside of master cylinder. Remove filler cap and diaphragm. Drain any remaining fluid from cylinder. On dual master cylinder used on Bronco and "E" & "F" Series vehicles, remove stop bolt from bottom of master cylinder.
  2. On all models, remove proportioning valve (if equipped). Depress piston, and remove snap ring from end of master cylinder bore. See Figure and Figure . Remove piston assembly from cylinder bore. Carefully apply air pressure in outlet port of cylinder to remove remaining piston assembly from bore.
NOTE: Manufacturer does not recommend honing of cylinder bore.
scientia non olet · About LEMON Manuals