Sliding Glass Panel Height (Front Area of Glass)

1. From inside the vehicle, move the sun shade rearward.
2. Pull down on the moulding to disengage the three retaining clips. Remove the moulding.
3. Loosen the installation screw.
4. Turn the adjusting screw clockwise to raise the sliding glass panel and counterclockwise to lower the glass panel. See Fig 1.
5. Tighten the installation screw.
6. Close the glass sliding panel and verify that the adjustment between the glass sliding panel and the roof is not greater than 1.5mm (0.06 inch).
7. If further adjustment is necessary, repeat steps  3- 6 .

Fig 1: Adjusting Sliding Glass Panel Height

Courtesy of FORD MOTOR CO.