LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1992 >> Crown Victoria Base, AOD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Overhaul - AOD >> Component Disassembly & Reassembly >> Oil Pump & Intermediate Clutch Piston >> Reassembly

Oil Pump & Intermediate Clutch Piston: Reassembly

  1. Install drive gear and driven gear into pump body with chamfer on both gears facing into pump body. Position stator support on pump body. Install and tighten retaining bolts to specification. See TORQUE SPECIFICATIONS  . Install pump body-to-case seal around outer diameter of pump body.
  2. Install NEW seals on intermediate clutch piston. Seal lips point away from spring posts. Coat piston seal and pump body sealing area with petroleum jelly. Use Seal Protector (T80L-77005-A) and install piston in pump body, ensuring piston bleed hole is located at 12 o'clock position (toward top of transmission case).
  3. Snap spring retainer assembly into place on pump body using even pressure. Install seal rings on stator support. The 2 larger rings are installed closest to pump.
Fig 1: Exploded View of Oil Pump & Intermediate Clutch
G92C14623Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals