Installation (Tempo & Topaz Tilt Wheel)
- Install lock cylinder housing on outer tube. Insert steering shaft into outer tube. Install tilt casting with tilt spring in position, ensuring tilt lock lever is latched in uppermost tilt position. Insert tilt pivot pins using "C" clamp. Pivot pins must be flush with outer casting surface.
- Install upper bearing retaining ring, upper bearing plate and conical spring. Press conical spring onto steering shaft until spring snaps into groove. Install multifunction switch.
- Connect steering shaft to intermediate shaft using connecting clamp at lower end of steering shaft. Install steering column. Install steering wheel. Connect battery ground cable. Check AIR BAG light for system faults.