LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1992 >> Crown Victoria Base, AOD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag Restraint Systems >> Removal & Installation >> Steering Wheel >> Installation

Steering Wheel: Installation

  1. Ensure vehicle front wheels are in straight-ahead position. Route clockspring wiring harness through steering wheel opening at 3 o'clock position. Position steering wheel onto steering shaft and align reference marks.
  2. Ensure air bag clockspring wire is not pinched when positioning steering wheel. Install new steering wheel retaining bolt and tighten to specification. See TORQUE SPECIFICATIONS  table. Connect speed control wiring harness connector to steering wheel and secure connector assembly into steering wheel clip.
  3. Install driver-side air bag module. See DRIVER-SIDE AIR BAG MODULE  . Activate SRS. Check AIR BAG warning light to ensure system is functioning properly. See TESTING - SYSTEM OPERATION CHECK  .
scientia non olet · About LEMON Manuals