LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1992 >> Crown Victoria Base, AOD >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Controls - System/Component Tests - EEC-IV >> Emission Systems & Sub-Systems >> Exhaust Gas RECIRCULATION (EGR) >> EGR Solenoid

EGR Solenoid

Remove EGR solenoid harness connector. Measure resistance across solenoid terminals. Resistance should be 65-110 ohms. Set DVOM to 200-k/ohm scale. Measure resistance between each solenoid terminal and ground or side of solenoid. Resistance should be greater than 10 k/ohms. If resistance is not as specified in either test, replace solenoid.

scientia non olet · About LEMON Manuals