Pinpoint Test WB Battery Input Warning Never Comes On Or Always Comes On

Verifying Condition: Ensure that system for which warning comes on operates correctly. If system does not operate correctly, repair system as necessary. If system operates correctly, go to step 2).
Observing Condition: Turn ignition on. Observe warning light. If warning is always on, go to step 3). If warning never comes on, go to step 7).
Checking Switch: Turn ignition off to reset warning. Unplug connector from appropriate switch or module. Turn ignition on. Observe warning light.
If warning comes on, go to step 5). If warning does not come on, service appropriate switch or module.
Checking Wiring: Turn ignition off. Remove instrument cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION. Check for continuity at wiring circuit at appropriate instrument cluster connector terminal. See BATTERY INPUT WARNING table.
If no continuity exists, replace instrument cluster. If continuity exists, repair short in wiring circuit.
Checking Switch: Turn ignition off. Unplug electrical connector from appropriate switch or module. Connect jumper wire between positive battery terminal and warning wiring circuit at switch or module.
Turn ignition on. Observe warning light. If warning comes on, service switch or module. If warning does not come on, remove jumper wire and go to step 9).
Checking Wiring: With jumper wire removed, turn ignition off. Remove instrument cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION. Check continuity between instrument cluster connector pin for appropriate warning circuit and connector at switch or module. See BATTERY INPUT WARNING table.
If continuity exists, replace instrument cluster. If no continuity exists, repair open in wiring circuit.

BATTERY INPUT WARNING

Warning	Connector & Pin No.	Wire Color
High Beam	C1 Pin 4	GRY/WHT
Left Turn Signal	C1 Pin 6	LT GRN/WHT
Right Turn Signal	C1 Pin 5	WHT/LT BLU
Safety Belt	C1 Pin 11	DK GRN/LT GRN