LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1992 >> Crown Victoria Base, AOD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Steering Column Switches >> Testing >> Ignition Switch >> Continental, Crown Victoria, Grand Marquis, Mark VIII, Sable, Taurus & Town Car

Continental, Crown Victoria, Grand Marquis, Mark VIII, Sable, Taurus & Town Car

  1. Check for continuity between specified terminals with switch in each position. See Fig 1. If continuity is not as specified, or is poor in any switch position, replace ignition switch.
    Fig 1: Ign. Switch ID (Continental, Crown Victoria, Grand Marquis, Mark VIII, Sable, Taurus & Town Car)
    G93A40220Courtesy of FORD MOTOR CO.
  2. Continuity should exist between terminals B5 and I1 with switch in START and RUN positions only. Continuity should not exist for all other switch positions.
  3. Continuity should exist between terminals B5 and A1 with switch in ACC position only. Continuity should not exist for all other switch positions.
  4. Continuity should exist between terminals A1 and B1 with switch in RUN position only. Continuity should not exist for all other switch positions.
  5. Continuity should exist between terminals A2 and B2 with switch in RUN position only. Continuity should not exist for all other switch positions.
  6. Continuity should exist between terminals A3 and B3 with switch in RUN position only. Continuity should not exist for all other switch positions.
  7. Continuity should exist between terminals A4 and B4 with switch in RUN position only. Continuity should not exist for all other switch positions.
scientia non olet · About LEMON Manuals