With Antilock Brakes

CAUTION: Brake fluid will damage electrical connections and painted surfaces. Use shop cloths, drip pans and fender covers to prevent brake fluid from contacting these areas.

1. Depress brake pedal several times to exhaust all vacuum in system.
2. Remove brake tubes from primary and secondary outlet ports of master cylinder and pressure control valves (wagon only). Cover the ends of the lines to prevent dirt from entering system.
3. Disconnect brake warning indicator connector.
4. Disconnect Hydraulic Control Unit (HCU) supply hose at master cylinder and secure in a position to prevent loss of brake fluid.
5. Remove two nuts retaining master cylinder to brake booster assembly.

Master Cylinder:

6. Slide master cylinder forward and upward from vehicle.