Moving Driver's Side Carrier From B-Pillar to A-Pillar

With the door closed and the ignition in the ON position, the control module checks B-pillar limit switch Pin No. 13, for a grounded condition, the inertia switch Pin No. 12 for an open condition, and the A-pillar limit switch Pin No. 5 for an open condition. If the A-pillar limit switch is not activated (open/not grounded), the control module will supply voltage to the retractor motor, sending the carrier from the B-pillar to the A-pillar (Voltage to Pin Nos. 3 and 4, Pin Nos. 2 and 17 grounded). The carrier will travel toward the A-pillar until the A-pillar limit switch is activated (Pin No. 5 is grounded). If Pin 5 is grounded, or if the inertia switch is tripped (Pin No. 12 grounded), the carrier will not move.