LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1991 >> Probe LX, Automatic >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Overhaul >> Removal & Installation >> NIPPONDENSO 10PA17 & 10PA17A Shaft Seal >> Installation

NIPPONDENSO 10PA17 & 10PA17A Shaft Seal: Installation

  1. Lubricate new shaft seal with refrigerant oil. DO NOT touch sealing surfaces. Using Shaft Seal Installer (T89P-19623-F), press seal into front head and install snap ring. Install felt dust seal and dust seal retainer.
  2. Lubricate Shaft Seal Protector (T89D-19623-C) and front head "O" ring with refrigerant oil. Install shaft seal protector on crankshaft. Install a new front head "O" ring on cylinder assembly.
  3. Install front head on cylinder assembly. Ensure dowel pins are aligned. Use care when guiding shaft seal protector through seal opening. Remove shaft seal protector.
  4. Install through bolts with NEW brass washers. Diagonally tighten bolts to 19 ft. lbs. (26 N.m). Install clutch assembly. Add amount of refrigerant oil that was drained to compressor. Install compressor. Evacuate and recharge system. Perform leak test.
scientia non olet · About LEMON Manuals