LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1991 >> Probe LX, Automatic >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Overhaul >> Removal & Installation >> NIPPONDENSO 10PA17 & 10PA17A Clutch Assembly >> Removal

NIPPONDENSO 10PA17 & 10PA17A Clutch Assembly: Removal

  1. Remove compressor shaft bolt and discard. Remove clutch plate and shims. If clutch hub cannot be removed by hand, thread a 8-mm bolt in center of clutch plate. Tighten bolt and remove clutch plate.
  2. Remove pulley assembly retaining snap ring. Remove pulley assembly. Remove snap ring and disconnect clutch coil electrical wiring. Remove clutch coil.
scientia non olet · About LEMON Manuals