LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1991 >> Probe LX, Automatic >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Overhaul >> Removal & Installation >> NIPPONDENSO 10P15A Shaft Seal >> Removal

NIPPONDENSO 10P15A Shaft Seal: Removal

  1. Discharge system using approved refrigerant recovery/recycling equipment and remove compressor. Drain oil from compressor and record amount for reassembly. Remove clutch assembly. See NIPPONDENSO 10P15A CLUTCH ASSEMBLY R & I in this article.
  2. Remove manifold assembly from top of compressor. Clean compressor front hub area. Using Ring Remover (T71P-19703-C), remove retaining ring from front of compressor shaft.
  3. Remove felt seal from front of compressor. Remove front head retaining bolts and front head from compressor. Remove snap ring from rear of front head. Remove seal from rear of front head.
scientia non olet · About LEMON Manuals