LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1991 >> Probe LX, Automatic >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Overhaul >> Removal & Installation >> NIPPONDENSO 10P15, 10P15F Shaft Seal >> Removal

NIPPONDENSO 10P15, 10P15F Shaft Seal: Removal

  1. Discharge system using approved refrigerant recovery/recycling equipment and remove compressor. Drain oil from compressor and record amount for reassembly.
  2. Mount compressor in vise claMFIng on mounting ears. Using Spanner (T81P-19623-MH), hold clutch plate and remove crankshaft nut. Pull clutch plate from compressor using Clutch Plate Remover (T80L-19703-B). Remove clutch plate shims.
  3. Clean compressor front hub area. Remove felt packing and dust seal retainer from inside compressor nose. See Figure. Using Shaft Key Remover (T81P-19623-NH), remove key from shaft.
  4. Remove seal seat retaining snap ring. Clean inner bore of compressor nose. Using Shaft Seat Remover/Installer (T87P-19623-B), remove seal seat.
  5. Using Shaft Seal Remover/Installer (T87P-19623-C), remove seal by pushing downward on shaft seal remover/installer and rotating clockwise to engage seal tangs. Pull seal from compressor.
scientia non olet · About LEMON Manuals