LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1991 >> Probe LX, Automatic >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Overhaul >> Removal & Installation >> NIPPONDENSO 10P13 Shaft Seal >> Removal

NIPPONDENSO 10P13 Shaft Seal: Removal

  1. Discharge system using approved refrigerant recovery/recycling equipment and remove compressor. Drain oil from compressor and record amount for reassembly. Using Clutch Holder (1014), hold clutch plate and remove crankshaft nut.
  2. Pull clutch plate from compressor using Clutch Plate Remover (T80L-19703-B). Remove clutch plate shims. Clean compressor area around seal. Remove felt packing and dust seal retainer from nose of front cover. See Figure.
  3. Using Key Remover (T81P-19623-NH), remove key from compressor shaft. Remove seal seat retaining snap ring. Remove seal seat from compressor using Seal Seat Remover/Installer (T87P-19623-B).
  4. Place Seal Remover/Installer (T87P-19623-C) on compressor. Rotate seal remover/installer clockwise until tangs engage in seal. Pull seal from compressor.
scientia non olet · About LEMON Manuals