LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1991 >> Probe LX, Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 3.0L V6 - VIN [U] >> Removal & Installation >> Oil Pan >> Removal (Probe)

Removal (Probe)

  1. Disconnect negative battery cable. Raise and support vehicle. Drain engine oil. Remove starter. Remove transaxle-to-cylinder block braces.
  2. Disconnect low oil level sensor connector at oil pan. Disconnect exhaust pipe from exhaust manifold. Remove water pump. See WATER PUMP .
  3. Remove pump mounting bracket and the automatic tensioner. See Figure. Remove bolts/nuts from front of right crossmember below oil pan. Loosen but DO NOT  remove bolts/nuts from rear of right crossmember below oil pan.
  4. Allow crossmember to lower as far as possible. Remove retaining bolts, oil pan and gasket.
scientia non olet · About LEMON Manuals