LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1991 >> Probe LX, Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 3.0L V6 - VIN [U] >> Removal & Installation >> Front Cover Oil Seal >> Removal (Probe)

Removal (Probe)

  1. Disconnect negative battery cable. Remove accessory drive belts. Raise and support vehicle. Remove right front wheel. Remove plastic inner fender shield.
  2. Support engine with floor jack. Remove right engine mount and spacer from water pump bracket (M/T equipped models). Remove upper engine mount at timing belt cover. Lower floor jack, allowing engine to rest on remaining mounts.
  3. Remove crankshaft damper bolt. Using Crankshaft Damper Remover (T58P-6316-D), remove crankshaft damper from crankshaft. Remove right subframe-to-body bolts/nuts. Pull subframe downward and remove crankshaft damper. Using Seal Remover (T70P-6B070-B), remove seal from front cover.
scientia non olet · About LEMON Manuals