LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1991 >> Probe LX, Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 3.0L V6 - VIN [U] >> Overhaul >> Cylinder Head

Cylinder Head

NOTE: When valve and/or valve seat are machined, valve clearance is reduced and may cause improper valve operation. Valve lifter must be collapsed and clearance checked. See, in this article, VALVE CLEARANCE ADJUSTMENT  under ADJUSTMENTS.

Check cylinder head warpage at deck surface. Resurface cylinder head if warpage exceeds specification. See CYLINDER HEAD  table under ENGINE SPECIFICATIONS at end of article.

CAUTION: DO NOT  machine more than .010" (.25 mm) from cylinder head original thickness.
scientia non olet · About LEMON Manuals