Water Pump: Removal

Drain cooling system. Remove accessory belts. Remove idler bracket from engine. Disconnect heater hose at water pump. Remove water pump pulley bolts. Pulley will remain loose on hub due to insufficient clearance.
On Probe model, remove 3 water pump mounting bolts. See Fig 2. On Sable and Taurus, remove 11 water pump mounting bolts. See Fig 3. On all models, lift water pump assembly up and out of vehicle.

Fig 1: Exploded View of Timing Cover/Water Pump Assembly

Courtesy of FORD MOTOR CO.

Fig 2: Exploded View of Probe Water Pump

Courtesy of FORD MOTOR CO.

Fig 3: Exploded View of Sable & Taurus Water Pump

Courtesy of FORD MOTOR CO.