LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1991 >> Probe LX, Automatic >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Overhaul >> Rear Brake Caliper >> Disassembly

Rear Brake Caliper: Disassembly

  1. Remove caliper. See REAR BRAKE CALIPER & DISC PADS  under REMOVAL & INSTALLATION. Open bleeder screw and drain fluid out through brake hose fitting. Remove caliper guide bushing and dust boots. Pry snap ring off dust boot and discard dust boot.
  2. Using Brake Piston Remover (T75P-2588-B), rotate piston counterclockwise and remove piston from adjuster spindle. Carefully remove piston seal. Remove snap ring. See Fig 1 . Remove stopper, adjusting spindle and connecting link. Remove and discard "O" ring from adjusting spindle.
  3. Remove parking brake return spring. Remove nut and lock washer. Match mark operating lever-to-shaft position. Remove operating lever from shaft. Remove seal and dust boot, shaft, and needle bearing from caliper.
Fig 1: Exploded View of Rear Caliper Assembly
G106769Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals