LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1991 >> Probe GT, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.2L 4-CYL - VIN [C] & 2.2L 4-CYL Turbo - VIN [L] >> Removal & Installation >> Rocker Arms & Valve Lash Adjusters >> Installation

Rocker Arms & Valve Lash Adjusters: Installation

  1. To install, reverse removal procedure. Ensure all camshaft bearing caps are installed in original location with arrow pointing toward front of engine. If camshaft bearing caps were removed, apply silicone sealant in proper areas. See Fig 2.
  2. Tighten rocker arm bolts evenly to specification. See TORQUE SPECIFICATIONS  table at end of article.
  3. Apply silicone sealant at front and rear housing-to-cylinder head areas before installing valve cover. See Fig 2. To complete installation, reverse removal procedure.
Fig 1: Identifying Rocker Arm Shafts
G106524Courtesy of FORD MOTOR CO.
Fig 2: Identifying Sealant Application Points
G106672Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals