Distance To Empty Does Not Go Below 200 Miles W/Empty Tank

Ensure fuel gauge is operating properly. If fuel gauge does not operate properly, go to CO DISPLAYED, GAUGE BLANKS OUT FUEL TANK SYMBOL & LIGHTS UP TOP 2 & BOTTOM 2 BARS OF GAUGE or CS DISPLAYED, GAUGE BLANKS OUT FUEL TANK SYMBOL & LIGHTS UP TOP 2 & BOTTOM 2 BARS OF GAUGE under PINPOINT TESTS.
If fuel gauge operates properly, verify that speedometer is operating properly. If speedometer does not operate properly, go to SPEEDOMETER READS 0 MPH AT ALL SPEEDS WITH VEHICLE IN MOTION under PINPOINT TESTS.
If speedometer operates properly,verify continuity and absence of shorts in circuit No. 305, between cluster connector "A" (terminal No. 11) at the instrument cluster connector and Data Output Line (DOL) circuit (terminal No. 34) at the ECA connector. If there is no continuity or shorts are present, repair wiring of circuit No. 305 as necessary. See Figure.
If continuity is present and there are no shorts, ensure the presence of a DOL signal from the ECA. With key off, connect breakout box to ECA or check for signal output at cluster connector "A" (terminal No. 11). Set DVOM on 20-volt scale. Start engine and measure voltage at test pin No. 34 (DOL circuit) at the breakout box. Voltage should be 10-12 volts.
NOTE: The ECA computes fuel usage and outputs this signal on the DOL circuit. The DOL signal is a digital pulse type. Duty-cycle on-time is approximately 5% at idle and increases with engine load and RPM.
If ECA signal on DOL circuit is present, replace EIC (fuel computer module). If ECA signal is absent, replace ECA, reconnect components and retest system.