Installation (Crown Victoria, Grand Marquis, Mark VII, Sable, Taurus & Town Car)
- Ensure front wheels are in straight-ahead position and steering shaft alignment mark is at 12 o'clock position.
- Route contact assembly and clockspring wiring harnesses through steering wheel opening at 3 o'clock position. Position steering wheel onto steering shaft, ensuring steering wheel and shaft alignment marks are aligned.
- Install new steering wheel bolt. Tighten to 23-33 ft. lbs. (31-45 N.m).
- Connect contact assembly electrical connector to cruise control/horn switch electrical connector. Connect clockspring electrical connector to air bag module and install module.