Installation (Crown Victoria, Grand Marquis, Mark Vii, Mustang, Sable, Taurus & Town Car)

1. Ensure front wheels are in straight-ahead position and steering shaft alignment mark is at 12 o'clock position. Install contact assembly.
2. If installing original contact assembly, remove tape from rotor and stator. If installing new contact assembly, remove plastic locking insert.
3. Install lower shroud. Install lower trim panel to dash panel. Install right and left lower moldings to dash panel.

Fig 1: Crown Victoria, Grand Marquis & Town Car Steering Column Components (Tilt Wheel)

Courtesy of FORD MOTOR CO.

Fig 2: Mark VII, Sable & Taurus Steering Column Components (Tilt Wheel)

Courtesy of FORD MOTOR CO.