Rear Caliper - Mark VII
NOTE:
On Mark VII models, it is possible to over-adjust rear brakes. A partial brake system failure, with only rear brakes operational, can be encountered. Check and adjust piston position and perform caliper adjustment.
- Start engine and let idle. Pump brakes lightly about 40 times. Allow at least one second between pedal applications. Check parking brake for excessive travel and very light effort. If either condition exists, repeat pumping brakes.
- If either condition still exists, check parking brake cable for proper tension. Parking brake lever at caliper must return to full stop position when released. See appropriate PARKING BRAKE underADJUSTMENTS .