LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Transmission >> Transfer Case >> Diagnosis & Overhaul - Borg-WARNER 1350 & 1356 >> Service (In Vehicle) >> Front Output Shaft Oil Seal R & I >> Removal

Front Output Shaft Oil Seal R & I: Removal

  1. Raise vehicle on hoist. Remove front drive shaft from axle input yoke. Loosen clamp retaining drive shaft boot to transfer case. Pull drive shaft and boot assembly out of transfer case front output shaft.
  2. Place a drain pan under transfer case, remove drain plug and drain fluid from case. Remove oil seal from front output housing bore with Seal Remover (1175-AC) and Slide Hammer (T50T-100-A).
scientia non olet · About LEMON Manuals