LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Transmission >> Manual Trans >> Removal & Installation - M/T >> Transmission Removal & Installation >> MITSUBISHI Fm132 (2WD) & Fm146 (4WD) >> Installation

MITSUBISHI Fm132 (2WD) & Fm146 (4WD): Installation

  1. Ensure mating surfaces and locating dowels are free of burrs. Ensure transmission input shaft is clean and free of rust. Place transmission on jack and position under vehicle. Raise transmission into position and start input shaft into clutch disc.
  2. Align splines on input shaft with splines in clutch disc. Move transmission forward until clutch housing seats on locating dowels. Install bolts retaining clutch housing-to-engine block.
  3. Tighten bolts to specifications. To complete installation, reverse removal procedure. Fill transmission with 3.4 qts. (3.2L) of SAE 80W lubricant.
scientia non olet · About LEMON Manuals