LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Transmission >> Manual Trans >> Removal & Installation - M/T >> Transmission Removal & Installation >> MAZDA M50D (Bronco, "E" & "F" Series 2WD) >> Installation

MAZDA M50D (Bronco, "E" & "F" Series 2WD): Installation

  1. Ensure transmission input shaft splines are clean and free of rust. Place transmission on jack. Install guide studs in engine block. Raise transmission until input shaft splines are aligned with clutch disc splines.
  2. Slide transmission forward onto guide studs. Remove guide studs and install clutch housing-to-engine bolts. Tighten to specifications. To complete installation, reverse removal procedure. Fill with 3.8 qts. (3.6L) of Mercon ATF (XT-2-QDX or EAZ-19582).
scientia non olet · About LEMON Manuals