LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Transmission >> Manual Trans >> Removal & Installation - M/T >> Transmission Removal & Installation >> MAZDA M50D (AEROSTAR, Bronco II & Ranger) >> Installation

MAZDA M50D (AEROSTAR, Bronco II & Ranger): Installation

  1. Ensure mating surfaces and locating dowels are clean and free of burrs. Ensure input shaft is clean and free of rust. Place transmission on jack and position under vehicle. Raise transmission and align input shaft with clutch splines. Move transmission forward until clutch housing seats on dowel pins.
  2. Install and tighten bolts to specifications. To complete installation, reverse removal procedure. Fill transmission with 3.8 qts. (3.6L) of Mercon ATF (XT-2-QDX or EAZ-19582).
scientia non olet · About LEMON Manuals