LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Transmission >> Manual Trans >> Removal & Installation - M/T >> Transmission Removal & Installation >> Borg-WARNER T-18 4-Speed (Bronco & F150/250 4WD) >> Removal

Borg-WARNER T-18 4-Speed (Bronco & F150/250 4WD): Removal

  1. Remove floor mat and body floor pan cover. Place shift lever in Reverse position. Remove gearshift cover. Remove insulator and dust cover. Remove transfer case shift lever, shift ball and boot as an assembly.
  2. Remove transmission shift lever, shift ball and boot as an assembly. Raise vehicle on hoist. Remove drain plug and drain transmission and transfer case. Disconnect rear and front drive shafts and wire them aside.
  3. Remove shift linkage from transmission. Remove speedometer cable. Position transmission jack under transfer case. Remove transfer case-to-transmission bolts. Remove transfer case.
  4. Remove rear support bracket-to-transmission bolts. Position transmission jack under transmission. Remove rear support bracket brace. Remove transmission-to-clutch housing bolts. Remove transmission.
scientia non olet · About LEMON Manuals