Borg-WARNER 1356 (Bronco & "F" Series): Removal
- Raise vehicle on hoist. Place a drain pan under transfer case, remove drain plug and drain fluid from transfer case. Disconnect 4WD indicator switch wire connector at transfer case. Disconnect front drive shaft from front output yoke.
- Disconnect rear drive shaft from rear output shaft yoke. Disconnect speedometer cable assembly from transfer case rear bearing retainer. Disconnect vent hose from transfer case.
- Support transfer case with transmission jack. Remove bolts retaining transfer case to transmission adapter. Slide transfer case rearward off of transmission output shaft. Lower transfer case from vehicle and remove gasket between transfer case and adapter.