LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Transmission >> Clutches >> Adjustments >> Clutch Master Cylinder Push Rod Length Adjustment >> Bronco, "E" & "F" Series

Bronco, "E" & "F" Series

  1. Ensure attaching nut on left side of clutch pedal is tight. Remove clutch master cylinder push rod from the cross shaft lever pin. If push rod is in alignment with the cross shaft lever pin, adjustment is okay.
  2. If push rod is not in alignment with the cross shaft lever pin, reinstall push rod to the cross shaft lever pin. Pump clutch pedal several times to reset position of shaft to the pedal slot.
  3. Remove clutch master cylinder push rod from lever pin and evaluate alignment. If push rod is aligned with pin, adjustment is complete. If the 2 components are still not in alignment, replace cross shaft lever.
scientia non olet · About LEMON Manuals