LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Overhaul - 10-CYL >> Shaft Seal R & I >> NIPPONDENSO/Ford 10PA17A >> Removal

NIPPONDENSO/Ford 10PA17A: Removal

  1. Install compressor in Holding Fixture (T89P-19623-D) and clamp fixture in a vise. Remove clutch plate, pulley assembly and clutch coil. Using a 6 mm Allen wrench, remove 5 compressor through bolts. Pull front head from compressor using care not to scratch sealing surface.
  2. Reach down inside front head and remove felt seal and retainer. Using "O" Ring Remover (T71P-19703-C), remove "O" ring. Position compressor front head nose up on cardboard on flat surface. Using Shaft Seal Remover (T89P-19623-E), push shaft seal from head. Inspect front head for damage to sealing surface. Replace if needed.
scientia non olet · About LEMON Manuals