LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Overhaul - 10-CYL >> Shaft Seal R & I >> Ford FX-15 10-Cylinder >> Removal

Ford FX-15 10-Cylinder: Removal

  1. Remove clutch hub. Using "O" Ring Remover (T71P-19703-C) remove shaft seal felt. Thoroughly clean seal area of compressor. Using snap ring pliers, remove shaft seal snap ring.
  2. Position Shaft Seal Remover (T89P-19623-BH) over compressor shaft and push remover down against seal. Ensure end of remover is in seal and turn remover handle clockwise to expand remover tip. Pull shaft seal straight out.
scientia non olet · About LEMON Manuals