LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Overhaul - 10-CYL >> Clutch Assembly R & I >> NIPPONDENSO/Ford 10PA17A >> Removal

NIPPONDENSO/Ford 10PA17A: Removal

  1. Remove clutch plate retaining bolt and discard. Using 8 mm bolt, thread bolt into crankshaft and remove clutch plate. Remove clutch plate shims.
  2. Remove pulley assembly snap ring. Remove pulley assembly. Remove snap ring and disconnect clutch coil electrical wiring. Remove clutch coil.
scientia non olet · About LEMON Manuals