LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Clutch & Seal Removal & Installation >> NIPPONDENSO, 10P15A 10-CYL Clutch Assembly >> Installation

NIPPONDENSO, 10P15A 10-CYL Clutch Assembly: Installation

  1. Install clutch coil over locating pin and install snap ring. Connect electrical wiring.
  2. Install pulley. Ensure pulley bearing is aligned with compressor head. It may be necessary to gently tap pulley on shaft with plastic hammer. Install pulley retaining snap ring.
  3. Install shims and clutch plate. Install crankshaft nut and tighten to 10-12 ft. lbs. (14-16 N.m). DO NOT tighten nut with air tools. Using feeler gauge, measure clearance between clutch plate and pulley in several different areas.
  4. Proper clearance is .016-.028" (.41-.71 mm). If clearance is not correct, add or remove shims.
scientia non olet · About LEMON Manuals