LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Clutch & Seal Removal & Installation >> NIPPONDENSO 10PA20 10-CYL Shaft Seal >> Removal

NIPPONDENSO 10PA20 10-CYL Shaft Seal: Removal

  1. Discharge system using approved refrigerant recovery/recycling equipment and drain oil from compressor. Note amount of oil drained. Remove clutch plate, pulley assembly and clutch coil. Using a 6 mm Allen wrench, remove compressor through bolts. Pull front head from compressor. Use care not to scratch sealing surface.
  2. Reach down inside front head and remove felt seal and retainer. Remove "O" ring. Remove shaft seal snap ring. Push shaft seal from head. Inspect front head for damage to sealing surface. Replace if necessary.
scientia non olet · About LEMON Manuals